Activity Stream

Yes, they are 2 piece. If they interchange, I don't know. Would imagine if the vertical end mouldings are the same for all years, it would.

I also only spend what I can pay quickly. But sometimes it just seems best to get a bunch of things at once to keep the momentum going. Sometimes it...

This appears to be the same problem I`m having. To do everything I want to do to the car, to have it look and perform the way I would like, I`m going...

I've never looked at how much I've spent on the car up to now except it's fun to joke about putting $550 in headlights into a $500 car. Things I...

One reason it took me over 10 years to build my car is, I refused to build it on credit. Only put as much on the VISA that I could pay the balance at...

I took eight years off and became a carpenter, electician, plumber, and dry wall guy after buying our house. Pretty shortly I have to knock off again...

I know what your talking about. I have barely touched anything on my Aspen in the 2+ years since I moved to our new(to us) house as I have been doing...

I'm trying to plan out a build, so I'll let the intake ride for now. The trouble with planning a build is I want to do things 'better' and pretty...

You can use wiper blades from a late '60's Cadillac and Buick, also 18". The driver side one needs to be flattened out a bit but they look basically...

Yeah. I think I will just swap the springs out, thanks

I see the pic now. The arms look ok from the pic. I would just try and replace the springs if you find ones that work. I will know soon when I get...

The original housing should be a cast aluminum. The front intake gasket if original was a foam like material. It probably just got hard with age. If...

That is the part. I've looked around a bit and not seen it for less than about $100. Thanks. I've also seen all the talk about aftermarket parts...

You are probably correct on that I just never checked for flatness as it looked good when placed on the manifold.

I think it depends on the material the housing is made of. If it is billet aluminum it should be ok. Some of the chrome housings are junk. Some...

Every thermostat housing with an o-ring seal I have used leaked and you had to throw the o-ring away and use silicone anyway. Good luck if you use...

https://www.flashpowerparts.com/billet-parts-for-chevy-gm-engines/64-billet-thermostat-housings-water-neck-chrysler-mopar-hemi-0-degree.html

There is a housing with an o-ring seal but I think they are a little pricey.

In order to try to get the choke working better I replaced my thermostat. I thought maybe mine was just sticking open, but I found that the one in...

I`m going to try the VRP. My daughter lives fairly close to a Chemical Guys store and see said she would pick me some up.Thanks

Attachment didn`t show up for me. I have two used wiper arms. The springs seem to have good tension but the springs do show corrosion. I was going to...

Thanks guys, after further investigation, I have the original arms and blade holders, I did not look close enough to realize the arms do detach, ...

Mopar part number 3799124 trico. The number stamped on mine is 3056160 CAN 63. I found these on ebay so you get the idea but you could search...

There are some Chevrolet arm springs on ebay that look like they would work. I almost ordered them the other day. I asked them for the length and...

77 spitfire, Old post, but I was wondering how the D453 Dougs fit.

I had the same side pipes years ago (~1981) on my Roadrunner -- I LOVED the sound of cambered mufflers!!! :thumbsup::drool5: Everything is looking...

On the Vette before the photo shoot I went over the rubber items several times with Chemical Guys VRP. It makes hard / rigid rubber pieces feel like...