Search:

Page 1 of 7 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    12
    Views
    507

    I never did find a new valve for my car (one...

    I never did find a new valve for my car (one specifically for an Aspen) and ended up using one for a mid '90's Jeep. the diameter is the same but the thickness of the "groove" is different. Made a...
  2. Replies
    6
    Views
    240

    It appears the field and load relay was only used...

    It appears the field and load relay was only used in '76 and '77 F-body. Sorry, I've only a '79 catalog.
  3. Replies
    14
    Views
    642

    I couldn't resist backing the Aspen out

    Wish I could take it down the road but, that'll have to wait unfortunately.


    https://www.youtube.com/watch?v=dyZaDhNGGiA&t=8s
  4. Replies
    10
    Views
    662

    I meant no offense, was only wondering. :)

    I meant no offense, was only wondering. :)
  5. Replies
    8
    Views
    448

    I used urethane mounts that came from Springs 'n...

    I used urethane mounts that came from Springs 'n Things but you can use most any brand. The F-body uses the same ones as '73 and up B-body with a similar isolated sub-frame, the listings just never...
  6. Replies
    598
    Views
    63,517

    Well, Dorman..........That's code for Made in...

    Well, Dorman..........That's code for Made in China (cheaply and with not much quality control in most cases). There are good vacuum caps out there. Not sure what store might carry them though. At...
  7. Replies
    598
    Views
    63,517

    When the trim goes on, you know your getting...

    When the trim goes on, you know your getting nearer to the end of the project.

    BTW, green grass, leaves on the trees, above 5 degrees,,,,,,,,,,,you suck!:drool5:
  8. That's reason there's a couple of forum sites I...

    That's reason there's a couple of forum sites I USED to be a member of but am not anymore. They were like dealing with 2 year old's. This site is the opposite of that.
  9. Replies
    598
    Views
    63,517

    The panel board and carpeting showed up yesterday...

    The panel board and carpeting showed up yesterday for the trunk so, guess I don't have any excuse to put it off anymore except,,,,,,,,,,,I caught cold and feel like crap today.:sour: Maybe tomorrow...
  10. Replies
    598
    Views
    63,517

    It took a bunch of looking but I finally found...

    It took a bunch of looking but I finally found the service manual section that explains the operation of the electric choke. They hid it towards the end of the "EMISSION CONTROL" section.

    The...
  11. Replies
    1
    Views
    570

    Seems they moved from Nigeria and changed their...

    Seems they moved from Nigeria and changed their name. Duke Zeus? Really? lol
  12. Thread: P/S Gears

    by aspen79
    Replies
    16
    Views
    1,193

    For what it's worth, I put a FF stage 2 in my...

    For what it's worth, I put a FF stage 2 in my Aspen and am happy with it. HUGE improvement over the stock one I overhauled. BTW, I will NEVER overhaul a p.s gear ever again.
  13. Replies
    20
    Views
    5,051

    I can't speak for what HP/TQ they're advised (or...

    I can't speak for what HP/TQ they're advised (or mandatory)but, subframe connectors make a noticeable difference even on a stock S6 car. With them, the car feels more solid and the handling is...
  14. Replies
    598
    Views
    63,517

    You should be able o rotate the counter weight on...

    You should be able o rotate the counter weight on the right side exhaust manifold and then, it should come back on it's own with spring tension. They seize up more often than not unless they have...
  15. I had a FB acct for a few months but after...

    I had a FB acct for a few months but after getting put in jail for the second time, for "hate speech", I said screw it and deleted my acct. The "hate speech"? All I did was state conservative views...
  16. Well, there's goes the neighborhood! :D

    Well, there's goes the neighborhood! :D
  17. Replies
    5
    Views
    852

    Something is not quite right. The alternator...

    Something is not quite right. The alternator shouldn't be charging the battery constantly, no matter what the amperage, provided the battery is good. The alternator is technically a battery...
  18. Replies
    686
    Views
    71,465

    Sticky: Rain, snow, cold, wind, rain, crap. Pretty much...

    Rain, snow, cold, wind, rain, crap. Pretty much sums up the weather here lately. It's still "only" 20-25 degrees below average and tomorrow is no exception. A so called high of 36 and snow showers...
  19. Thread: Cruise Control

    by aspen79
    Replies
    21
    Views
    2,732

    The bell sounds are the speedo drum rubbing on...

    The bell sounds are the speedo drum rubbing on the magnet, which will also cause the needle to bounce and jump. The cable spins the magnet inside the drum (and they can't touch) and the drum is...
  20. Thread: Cruise Control

    by aspen79
    Replies
    21
    Views
    2,732

    Yes, that looks to be the correct one.

    Yes, that looks to be the correct one.
  21. Thread: Cruise Control

    by aspen79
    Replies
    21
    Views
    2,732

    You are correct. Only need the right cable to go...

    You are correct. Only need the right cable to go from the trans to speedometer.

    I did a brief search of Advance Auto, Rock Auto, etc and every one of them has the wrong trans end fitting. They all...
  22. Replies
    598
    Views
    63,517

    For paint runs you can either use a paint run...

    For paint runs you can either use a paint run razor and blockers to shave it down, then wet sand, finishing with 2,000 grit or finer followed by buffing or carefully wet sand the run out and then...
  23. Thread: Fuel Lines

    by aspen79
    Replies
    5
    Views
    882

    If it's what I'm thinking of, my 1981 D150 had...

    If it's what I'm thinking of, my 1981 D150 had one. It would be where the 3rd line from the filter (comes out the side of the filter) would hook to. It's sort of a fuel bleed port. My understanding...
  24. Replies
    4
    Views
    800

    "Why not?" Careful, that's how my car turned into...

    "Why not?" Careful, that's how my car turned into a 12 year project! lol

    Not a slant 6 but an idea for the tailpipes. I built them myself but a custom exhaust shop could bend them if you don't...
  25. That was a dealer installed A/C package on Ebay...

    That was a dealer installed A/C package on Ebay but the guy wanted $2,500 (I think it was) for it. The old York compressor wasn't R134a compatible either and R12, when you can find it, is VERY...
Results 1 to 25 of 158
Page 1 of 7 1 2 3 4