Search:

Page 1 of 7 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    73
    Views
    6,379

    I have seen the red rim edge also, mostly on the...

    I have seen the red rim edge also, mostly on the "fast and furious" (or is that slow and delirious, lol) type cars. Not keen on the cars themselves but the red does look good. Like you said, kind of...
  2. Replies
    592
    Views
    112,544

    But,,,,,,,,,,,,,,,,Bones,,,,,,,,,,,,,,,,,,,,,,,,I...

    But,,,,,,,,,,,,,,,,Bones,,,,,,,,,,,,,,,,,,,,,,,,I need,,,,,,,,,,,,,,,,,,,,,,,,,fuel.

    Dammit Jim, I'm a doctor not a gas station.

    LOL
  3. Replies
    699
    Views
    177,997

    Mine are attached with the stock mounting plates...

    Mine are attached with the stock mounting plates and "shocks".
  4. Replies
    699
    Views
    177,997

    When I did mine, I had the fittings and hoses...

    When I did mine, I had the fittings and hoses mocked up and marked for position already. The shop brazed a couple adapter fittings to the stock H-valve blockand conensor block to adapt to the new...
  5. Replies
    16
    Views
    3,536

    Dang man! I'm crying and it isn't even my car. ...

    Dang man! I'm crying and it isn't even my car.

    Jim is active on here again, btw.
  6. Replies
    842
    Views
    176,453

    Put the new EBC brake pads in. Didn't take a pic...

    Put the new EBC brake pads in. Didn't take a pic but scuffed the rotor surfaces with an angle die grinder and Roloc surface conditioning disc to break the glaze.

    Discovered something I have to do...
  7. Replies
    699
    Views
    177,997

    We ran into that once at work on a street rod....

    We ran into that once at work on a street rod. Beautiful braided SS A/C hoses but he had a leak. One where it leaks down over the course of a few months. Put florescent dye in he system and charged...
  8. Replies
    9
    Views
    3,087

    Yikes! It is a tad on the rough side, isn't it?...

    Yikes! It is a tad on the rough side, isn't it? Already had the frame rails "fixed" and there is a lot of bondo. I've never seen an F body with the firewall/cowl rotted out that bad, especially on...
  9. Replies
    13
    Views
    3,894

    A butt weld would work but, it'd be better if the...

    A butt weld would work but, it'd be better if the flange was over the outside of the pipe. My idea would be enlarge the holes in the flanges slightly so the pipe is a tight slip fit and then weld.
  10. Replies
    12
    Views
    3,372

    I never did find a new valve for my car (one...

    I never did find a new valve for my car (one specifically for an Aspen) and ended up using one for a mid '90's Jeep. the diameter is the same but the thickness of the "groove" is different. Made a...
  11. Replies
    6
    Views
    2,084

    It appears the field and load relay was only used...

    It appears the field and load relay was only used in '76 and '77 F-body. Sorry, I've only a '79 catalog.
  12. Replies
    14
    Views
    4,039

    I couldn't resist backing the Aspen out

    Wish I could take it down the road but, that'll have to wait unfortunately.


    https://www.youtube.com/watch?v=dyZaDhNGGiA&t=8s
  13. Replies
    15
    Views
    4,438

    I meant no offense, was only wondering. :)

    I meant no offense, was only wondering. :)
  14. Replies
    8
    Views
    2,947

    I used urethane mounts that came from Springs 'n...

    I used urethane mounts that came from Springs 'n Things but you can use most any brand. The F-body uses the same ones as '73 and up B-body with a similar isolated sub-frame, the listings just never...
  15. Replies
    842
    Views
    176,453

    Well, Dorman..........That's code for Made in...

    Well, Dorman..........That's code for Made in China (cheaply and with not much quality control in most cases). There are good vacuum caps out there. Not sure what store might carry them though. At...
  16. Replies
    842
    Views
    176,453

    When the trim goes on, you know your getting...

    When the trim goes on, you know your getting nearer to the end of the project.

    BTW, green grass, leaves on the trees, above 5 degrees,,,,,,,,,,,you suck!:drool5:
  17. That's reason there's a couple of forum sites I...

    That's reason there's a couple of forum sites I USED to be a member of but am not anymore. They were like dealing with 2 year old's. This site is the opposite of that.
  18. Replies
    842
    Views
    176,453

    The panel board and carpeting showed up yesterday...

    The panel board and carpeting showed up yesterday for the trunk so, guess I don't have any excuse to put it off anymore except,,,,,,,,,,,I caught cold and feel like crap today.:sour: Maybe tomorrow...
  19. Replies
    842
    Views
    176,453

    It took a bunch of looking but I finally found...

    It took a bunch of looking but I finally found the service manual section that explains the operation of the electric choke. They hid it towards the end of the "EMISSION CONTROL" section.

    The...
  20. Replies
    1
    Views
    1,766

    Seems they moved from Nigeria and changed their...

    Seems they moved from Nigeria and changed their name. Duke Zeus? Really? lol
  21. Thread: P/S Gears

    by aspen79
    Replies
    16
    Views
    4,290

    For what it's worth, I put a FF stage 2 in my...

    For what it's worth, I put a FF stage 2 in my Aspen and am happy with it. HUGE improvement over the stock one I overhauled. BTW, I will NEVER overhaul a p.s gear ever again.
  22. Replies
    23
    Views
    10,570

    I can't speak for what HP/TQ they're advised (or...

    I can't speak for what HP/TQ they're advised (or mandatory)but, subframe connectors make a noticeable difference even on a stock S6 car. With them, the car feels more solid and the handling is...
  23. Replies
    842
    Views
    176,453

    You should be able o rotate the counter weight on...

    You should be able o rotate the counter weight on the right side exhaust manifold and then, it should come back on it's own with spring tension. They seize up more often than not unless they have...
  24. I had a FB acct for a few months but after...

    I had a FB acct for a few months but after getting put in jail for the second time, for "hate speech", I said screw it and deleted my acct. The "hate speech"? All I did was state conservative views...
  25. Well, there's goes the neighborhood! :D

    Well, there's goes the neighborhood! :D
Results 1 to 25 of 167
Page 1 of 7 1 2 3 4